Configuring the Camera4-30 Basler A500kPRELIMINARY4.2.8 Camera Status CommandPurpose: The camera has been programmed to detect several error conditions. When an errorcondition is detected, a flag is set. The status command allows you to read the error flags.Type: This is a read only command.Read Command: Cmd-ID R/W-Flag Data Length Data0x43 1 2 -Response: Cmd-ID R/W-Flag Data Length Data0x43 0 2 2 BytesData Format: Byte 1 Each bit specifies an error condition (see table below).If a bit is set to 1, the error condition assigned to that bitis present. If the bit is set to 0, the error is not present.Byte 2 Each bit specifies an error condition (see table below).If a bit is set to 1, the error condition assigned to that bitis present. If the bit is set to 0, the error is not present.Byte 1Bit 0 No ExSync signal in the last 5 secondsBit 1 A reset has occurred.Bit 2 The camera is unlockedBit 3 ReservedBit 4 Unknown command ID specified in a read or write commandBit 5 A read or write command could not be executed;access deniedBit 6 The length member of the last command does not matchthe defined lengthBit 7 Parameter errorByte 2Bit 0 FPGA; general errorBit 1 FPGA; no FPGA firmware availableBit 2 No FPGA/ADC command list availableBit 3 Error in FPGA/ADC command list itemBit 4 User set is erroneousBit 5 Factory set is erroneousBit 6 EEPROM checksum error (this is a checksum used todetermine if the contents of the EEPROM are valid)Bit 7 No EEPROM command list available
