Baumer PosCon3D Operating Instructions Manual

en_BA_OxE7_PosCon3D.docx 5/64 Baumer Electric AG17.07.2014 14:21/tof V1.01 ANW_81125407 Frauenfeld, Switzerland2 Commissioning in 4 stepsAfter the sensor is connected and installed, configure it via the display, selecting either the "Edge", "Width" or"Gap" function and performing the other application-specific settings/measurement type within thesefunctions. Afterward the sensor is ready for operation and outputs the measuring value in mm to the screen.Optionally, the measuring field can be limited or the switching output can be configured.ConnectionInstallationFunction Edge Function Width Function GapLet's get startedOptional: Measuring field limitationOptional: Switching output2.1 ConnectionConnectionConnect the sensor according to the connectiondiagram. A shielded connection cable (8-pole M12)must be used.When everything is correctly connected, the sensorstarts up and the display lights up.Key functionsESC = BackESC 2 sec. = Main menuUP = Up/increase valueDOWN = Down/decrease valueSET = OKSET 2 sec. = Save valueSlide over all 4 keys:----> = Enables the panel if locked<---- = Jump to run modeSetting the languageThe language will be selected and confirmed bypressing SET for 2 seconds.EnglishDeutschItalianoFrançais1123456