214214214cab Produkttechnik GmbH & Co KGC - Cutter ParametersThe C command is used to set the parameters for the optional cutter or perforation cutter. The cuttingcommand uses the label counter to cut after a specified amount of printed labels or can be set to cut atthe job end. Additonally it is possible to perform a second cut (double-cut) in one label.Furthermore an optional perforation cutter is available, which can perforate and which is also able todo a "regular" cut.C x[,disp1[,disp2]]CRC - cutting commandx = cutting method - valid parameters are:amount = amount of labels after which a cut is processed.Possible values 1-9999e = cutting at the job end.Cuts once at the job end which is defined by the "A"(amount) command.s = cut at print start (before the first label. This command isonly executed once in the job and can be combinedwith " C amount ". disp1 is an optional offset in thechosen unit.p = perforate - requires the optional perforation cutter !sp = perforate at the start of the printjob ( requires theoptional perforation cutter !, and can be combinedwith " C amount ". disp1 is an optional offset in thechosen unit.disp1 = (displacement 1) - offset to the end of the defined labeldisp2 = (displacement 2) - offset to the first cutting position.(always positive values !)This double cut option offers the possibilityto cut off portions of a label. [disp2] is not available when the „cutbefore first label ( s) parameter is used. disp2 is only available forregular cuts and not for perforations !Please see also the "O" command to adjust the cutting time ( cutting depth ) for the perforationcutter. All measurements in millimeters or in inches (see the „m“ command)Optional cutter requiredSyntax:
