260260260cab Produkttechnik GmbH & Co KGS - Set Label SizeThis command defines the width and length of a label and has some additional options.S[ptype;]xo,yo,ho,dy,wd[,dx,col][;name]CRS - Set label sizeptype; = photocell type. Sets the type of label sensing. Optional parameter.It is recommended to set it in the label definition.e = endless (continuous) label material without die cuts. Labelssensor is switched off and the height is measured by theamount of micro steps of the printer´s transport motor.Important: the following character is a lower case L followedeither by 0,1 or 2 !!l0 = senses the reflective marker on the upper side of the labelmaterial. ( only if the printer is equipped with this sensor!!!)( l0 = small letter L + 0)l1 = sets the printer´s sensors for die cut labels with gap.( l1 = small letter L + 1)l2 = senses the reflective marker on the lower side of the labelmaterial. ( l2 = small letter L + 2)xo = horizontal displacement, shifts the starting point (zero point) of allhorizontal measurements to the left margin of the label.yo = vertical displacement, shifts the starting point (zero point) of allvertical measurements to the top margin of the label.ho = height of the label in transportation direction.dy = height of the label plus height of the gap. (Distance from thestarting point of the first label to the starting point of the next label)wd = label width measured from the right margin to the left margin.continued on the next page....Syntax:
