CAB a2+ Configuration Instructions

Also see for A2+: Operator's manual Operating instructions User configuration guide

CAB a2+ Configuration Instructions Manual pdf 55 page image

A2+/A4+/A6+/A8+Service functionsEdition 5/06 Configuration Instructions 556.6 Changing OEM nameYou can change the device designation with the OEM Name function.1. Insert service key into a USB master interface.2. Press the menu button.3. Select Service > OEM Name menu.4. Press the ↵ button.A list of available names is shown in the display.5. Use the S and T buttons to select the desired OEM name.6. Press the ↵ button.6.7 Cleaning intervalThe Cleaning interval function is used for additional printhead maintenance control. You can selectthe length of medium which passes the printhead in increments of 500 m after which the printhead is tobe cleaned.1. Insert service key into a USB master interface.2. Press the menu button.3. Select Service > Cleaning interval menu.4. Press the ↵ button.5. Select the desired value with the X and W buttons.6. Press the ↵ button.If the set length of the medium (label strip, transfer ribbon) has passed the printhead and an error occursin the flow of the medium (e.g. label end, transfer ribbon end), the Clean printhead! messageappears in the display. The error message for the error which occurred is not displayed until youacknowledge this message. As long as no errors occur in the medium flow, no messages are displayedand the print job is continued even if the cleaning interval has passed.You can deactivate the Cleaning interval function by setting the value Off.Access only when service key is inserted!Access only when service key is inserted!