Setup9S ETUPThis section provides instructions and guidelines for assembling the simulator and configuring theInstructor Workstation. Follow these steps to prepare for your simulation experience.NOTE: Replacement procedures are located in the Care and Maintenance section of this user guide.Before Beginning SetupProper operation of the simulator requires correct configuration. Before setting up the system, keep inmind these basic guidelines:• Read and understand the Cautions and Warnings located in the beginningof this User Guide.• Follow the sequence of the steps carefully.• Complete all steps in order.• Do not power on any components until instructed in the text.• Keep all original shipping materials, including boxes. Warranty and repairitems must be returned and shipped in their original packaging.• When unpacking the mannequin for the first time, careful use of boxcutters protects both the packaging and the product.Setting Up the Maternal Fetal Simulator1 Place Mannequin in the Work Area2 Power on the Mannequin3 Power on the Instructor Workstation4 Connect to the Wireless Network5 Connect the TouchPro CTG Monitor to the Wireless Network6 Connect the TouchPro Patient Monitor to the Wireless Network (optional)7 Start Müse8 Configure the Mannequin9 Fill the Bleeding Fill Tank (optional)
