69BTTracer Protocol Analyzer User’s ManualCATC Version 1.0• 79 Hops Standard• 23 Hops Japan• 23 Hops Spain• 23 Hops France• Reduced Hop - Restricts BTTracer to five hop frequenciesdefined in the test mode specification of the Bluetooth™Specification. When Reduced Hop or Single Frequency isselected, the Sync method is set to Test Mode and cannot bemodified by the user.• Single Frequency - Allows the the transmit and receive frequencyranges to be specified. Selecting this option highlights the "DUTXmit" and "DUT Recv" text boxes. When Reduced Hop orSingle Frequency is selected, the Sync method is set to Test Modeand cannot be modified by the user.• Enter values into the two text boxes to the set the transmit andreceive frequency ranges:• DUT Xmit Freq, MHz (+2402) – Allows the setting of thetransmit signal for the Device Under Test• DUT Recv Freq, MHz (+2404) – Allows the setting of thereceive signal for the Device Under TestSync MethodsNote If the selected Hop Sequence is "Reduced Hop" or "Single Frequency," the SyncMethod is set to "Test Mode" and cannot be modified by the user.Page Sync & Record"Page Sync and Record" is the recommended method of recording. "PageSync and Record" should be implemented before a piconet is established.This mode causes BTTracer to perform a General Inquiry and collect syncinformation from the specified slave device when it responds. BTTracerthen waits for the Master to begin paging the Slave devices. When pagingbegins, BTTracer synchronizes to the Master and begins recording.Note In order for this mode to work, the intended Slave must support "inquiry scan".The following steps describe the simplest way to use this mode:Step 1 Place both the "intended master" as well as its first "intended slave"into inquiry scan mode.