LOCAL MANAGEMENT4-2Cabletron supplies an RJ45 Cable Kit with the MicroMMAC-T. This kitincludes a UTP console cable with RJ45 connectors on each end. It alsoprovides adapters for DB9 or DB25 connections. Refer to the RJ45 CableKit Instruction Sheet for adapter pinouts and additional instructions.The following sections explain how to attach the console cable to themanagement terminal.4.1.1 Attaching the Management TerminalNOTE: To view booting and diagnostic test information during power-upor reset, connect the terminal to the MicroMMAC-T ‘s COM 2 port. SeeSection 5.3 for more information about POWER UP DIAGNOSTIC tests.To attach a management terminal to the MicroMMAC-T:1. Attach the connecting cable’s male RJ45 connector to either theCOM 1 port or the COM 2 port on the MicroMMAC-T as shown inFigure 4-1.2. Attach the female end (25-pin or 9-pin) to the COM port on theterminal.Figure 4-1. Management Terminal Connection4.1.2 Management Terminal Setup ParametersTable 4-1 lists the setup parameters for the Local Management terminal. Ifyou are using a Digital Equipment Corporation VT terminal, press F3 toaccess the Setup Directory. For PC emulations of VT terminals, refer to theemulator’s documentation for setup parameters.TOKEN RING HUB WITH LANVIEW®SUPPORTING 100 OHM STP CABLEMicroMMAC-24TMANAGEMENT TERMINALCOM PORTCOM 2 RJ45 PORTCONSOLE CABLE
