2-264 SmartSwitch ATM Switch Reference ManualRedundancyStatusRedundancyStatus(SmartSwitch 6500 Only)Use RedundancyStatus to display status of automatic TSM/CPU redundancy and CSM redundancy on the switch.OperatorsshowParametersThis attribute has no input parameters. Just type show redundancystatus at the switch prompt.Output Parameter Description[Admin Status] Administrative status of automatic TSM/CPU redundancy (whether or not automaticTSM/CPU redundancy has been set ON with the RedundancyOn attribute). Possiblevalues are: Enabled or Disabled. As indicated in the description for the [Oper Status]parameter, several conditions must be met before automatic TSM/CPU redundancy isoperational, regardless of whether it has been set ON.[Oper Status] Operational status of automatic TSM/CPU redundancy. Possible values are: Redundantor Not Redundant. Operational status is Redundant if all of the following are true:• A slave TSM/CPU is present.• Redundancy is set to ON, using the RedundancyOn attribute.• Slave and master modules run the same version of boot load and switchoperating firmware.Note Some early versions of TSM/CPU might support automatic mirroring of slaveand master configurations (configuration of the slave module is automaticallykept current with the master module) but not CPU switchover. In this case,operational status is Redundant, but you get the message “TSM/CPU does notsupport automatic CPU switchover.”[Active CPU] Indicates slot location of master CPU.[Standby CPU] Indicates whether a slave TSM/CPU is present or absent. If the module is present, slotlocation is provided.[Active CSM] Indicates slot location of master CSM.[Standby CSM] Indicates whether a slave CSM is present or absent. If the module is present, slot locationis provided.
