SmartSwitch ATM Switch Reference Manual 2-327SwitchConfigSwitchConfigUse SwitchConfig to manage switch-related parameters, such as switchname and IP address.Operatorsmodify, showParametersInput Parameter Description Value/Field Size Default[SwitchName] Name of the switch. 1-19 characters switch_1[IPAddress] IP address of Ethernet port on the switch. Dot decimal/7-15 characters10.0.0.1[IPNetMask] IP netmask of Ethernet port. Defaults tothe appropriate netmask, based on IPaddress class. Calculated from the firsttwo high bits of the IP address. Must bespecified only if IP subnets are beingused.Dot decimal/7-15 characters255.0.0.0,255.255.0.0 or255.255.255.0Output Parameter Description[Switch Name] Name of the switch. (Same as the [SwitchName] input parameter.[IP Address] IP address of the Ethernet port on the switch. (Same as the [IPAddress] inputparameter.)[IP Netmask] IP netmask of the Ethernet port. (Same as the [IPNetMask] input parameter.)[CPU MAC Address (Base)] Base MAC (media access control) address for the TSM/CPU module. There are128 addresses, starting at this base address. The first is used for the Ethernet portassociated with the TSM/CPU.[Chassis MAC Address (Base)] Base MAC address for the SmartSwitch 6500 chassis.[Power Mode] Whether or not the switch is configured for a redundant power supply.[Supply Installed] Which power supply is installed.[Supply ON] Which power supply is ON.
