Cabletron Systems SmartSwitch 6000 User Manual

Contents

Cabletron Systems SmartSwitch 6000 User Manual Manual pdf 100 page image

Chapter 5: Local Management5-546E123-50 and 6E133-49 User’s Guide5.15.13 Clearing NVRAMClearing NVRAM allows the user to clear all user-entered parameters,such as IP address and Community Names from NVRAM.Clear NVRAM as follows:1. Use the arrow keys to highlight the Clear NVRAM field.2. Use the SPACE bar to toggle the field to YES.3. Use the arrow keys to highlight SAVE at the bottom of the screen.4. Press ENTER. The warning shown in Figure 5-21 is displayed.!CAUTIONWhen the COM port is configured to perform the UPSapplication, all future Local Management connections must bemade by establishing a Telnet connection to the module.Ensure that the module has a valid IP address before savingchanges to the COM port application. If the module does nothave a valid IP address and the changes are saved, refer toAppendix C for instructions on clearing NVRAM in order toreestablish COM port communications.!CAUTIONClearing NVRAM will result in the loss of all user-enteredparameters. Do not proceed unless this procedure iscompletely understood.