Switch Configuration Screen6E123-50 and 6E133-49 User’s Guide5-63Port # (Read-Only)Lists each switch port on the module. If the number of ports is greaterthan eight, then the additional ports are listed on subsequent screens.MAC Address (Read-Only)Displays the hardware address assigned to each listed port.State (Read-Only)Disabled: Management disabled this interface. No traffic is received orforwarded while the interface is disabled.Listening: The switch is not adding information to the TransparentDatabase. The switch is monitoring BPDU traffic while preparing tomove from the learning to the forwarding state.Learning: The switch is learning the network address of this interface.The switch enters the learning state when the Transparent Database iscreated (during start-up or after being deleted), or when the SpanningTree Algorithm detects a network topology change.Forwarding: The switch is on line and this interface is forwarding traffic.Blocking: This interface will not forward any traffic through the switchbecause a loop condition has been detected by the STA.Status (Toggle)Allows the user to disable or enable a port by setting the status of thelisted interface to either ENABLED or DISABLED. To set the port status,refer to Section 5.18.3.5.18.1 Setting the STAThe Spanning Tree Algorithm (STA) setting allows the user to set themethod that the switches use to decide which is the controller (Root)switch when two or more switches are in parallel. The available selectionsare IEEE, DEC, and NONE.To set the STA, proceed as follows:1. Use the arrow keys to highlight the Type of STA field.2. Use the SPACE bar to step to the appropriate setting (IEEE, DEC, orNONE).
