Managing the Hub2-27Using the EMM-E6 Hub ViewManaging the HubIn addition to the performance information described in the preceding sections,the Hub View also provides you with the tools you need to configure your huband keep it operating properly. Hub management functions include settingpolling intervals, changing a RIC MIM’s channel assignment, setting a port’strunk type, and enabling and disabling ports at the module level andindividually.Setting the Polling IntervalsTo set the polling intervals used by SPMA and the EMM-E6:1. Click on to display the Device menu.2. Drag down to Polling Intervals, and release.NOTEThe snapshots of the Source Address List that you can obtain via this feature do not reflectthe current port security status of the SAT — that is, when Source Address Locking isenabled, you can still observe addresses being aged out of the table and new addressesbeing added as you refresh the Source Address List displayed in this window. However,the EMM-E6 remembers the addresses that were in the table when locking was enabled,and will continue to protect all locked ports from access by unauthorized sources. Formore information, see Locking Source Addresses in Chapter 6; see also Chapter 7,Security.Also, keep in mind that the port-level source address list provides information about asingle port only; for a complete list of source addresses communicating through the deviceas a whole, use the Source Addressing option on the Device menu. Again, see Chapter 6for more information.
