Alarm Configuration3-2Using Alarm ConfigurationUsing Alarm ConfigurationTo open the Alarms windowfrom the icon:1. Click on the appropriate EMM-E6 icon to display the icon menu.2. Drag down to Alarm Configuration and release.from the Hub View:1. In the Hub View, click on to display the Device menu.2. Drag down to Alarm Configuration and release to open the Repeater Alarmswindow.from the command line (stand-alone mode):1. From the appropriate directory type:spmarun r4al Figure 3-1. Repeater Alarms WindowNOTESThe spmarun script invoked first in the above command temporarily sets the environmentvariables SPMA needs to operate; be sure to use this command any time you launch anapplication from the command line. The script is automatically invoked when you launchthe application from the icon menu or from within the Hub View.If you wish to change any Alarm Configurations, be sure to use a community name withat least Read/Write access. If you only wish to view current settings, a community namewith Read access will be sufficient.If there is a hostname mapped to your EMM-E6’s IP address, you can use in place of to launch this application. Please note, however, that thehostname is not the same as the device name which can be assigned via LocalManagement and/or SPMA; you cannot use the device name in place of the IP address.
