Link/Seg Traps4-6Enabling and Disabling Link/Seg TrapsViewing and Configuring Link/Seg Traps for PortsTo enable or disable Link and Segmentation traps for individual ports:1. In the Repeater Link/Seg Traps window, select a repeater in the scroll list.2. Click mouse button 1 on ; the port traps window, Figure 4-4, willappear.Figure 4-4. The Port Traps Window3. In the port traps window, click mouse button 1 to select the port or ports forwhich you wish to configure traps. If the Set Trap Status For field displaysSelected Ports (the default setting), you can click to select any ports; to de-select any highlighted port, click on it again. If the selectionAll Ports onModule is displayed in the Set Trap Status For field, you can select only oneport at a time; trap status will be set for all ports on the same module as theselected port. If the selectionAll Ports on Repeater is displayed in the SetTrap Status For field, all available ports will be automatically selected; if youde-select any port, the Set Trap Status For field will automatically revert totheSelected Ports setting. To change the setting in the Set Trap Status Forfield, click on the currently displayed setting, and drag down to select a newsetting.4. Click on the appropriate selection in the Link Traps field to Enable or Disablelink traps for the selected modules, as desired.
