SNMP Community Names Screen2M46-04R/2M46-04RDC User’s Guide5-31super-user This community name gives the user read-writeaccess to the 2M46-04R MIB objects andallows the user to change all modifiableparameters including community names, IPaddresses, traps, and SNMP objects.5.8.1 Establishing Community NamesThe password used to access Local Management at the Password Screenmust have super-user access to view and edit the SNMP CommunityNames screen. Using a password with read-only or read-write access doesnot allow the user to view or edit the SNMP Community Names screen.To establish community names, proceed as follows:1. Use the arrow keys to highlight the Community Name field adjacentto the selected access level.2. Enter the password in the field (maximum 31 characters).3. Press ENTER.4. Repeat steps 1 through 3 to modify the other community names.5. Use the arrow keys to highlight SAVE at the bottom of the screen andpress ENTER. The message “SAVED OK” displays. The communitynames are saved to memory and their access modes implemented.NOTEAny community name assigned in the SNMP CommunityNames screen is a password to its corresponding level ofaccess to Local/Remote Management. The community nameassigned super-user access is the only one that gives the usercomplete access to Local/Remote Management.NOTEExiting without saving causes a “NOT SAVED?” message todisplay above the SAVE command. Edits will be lost if they arenot saved before exiting.
