Chapter 5: Local Management5-342M46-04R/2M46-04RDC User’s Guide5.10 SWITCH CONFIGURATION SCREENThe Switch Configuration screen, Figure 5-15, provides the basic setupoptions to make a switch operational in your network.To access the Switch Configuration screen from the Device ConfigurationMenu screen, use the arrow keys to highlight the SWITCHCONFIGURATION menu item and press ENTER. The SwitchConfiguration screen displays.Figure 5-15 Switch Configuration ScreenNOTEThe Switch Configuration screen will only display if theoperational mode of the device has been set to 802.1DSWITCHING or 802.1Q SWITCHING. Refer to Section 5.7.9for instructions on configuring the device to operate in thismode.NOTEPorts 1 and 2 of the Switch Configuration screen correspond tothe Fast Ethernet slots and ports 3 and 4 correspond to theHSIM slots.Firmware Revision: XX.XX.XXSwitch Configuration2314-18Device Type: 2M46-04RBOOTPROM Revision: XX.XX.XXPort #1234Statelearninglisteningblockingdisabled2M46-04R LOCAL MANAGEMENTEvent Message LineRETURNSAVEMAC Address00-00-1D-00-00-0000-00-1D-00-00-0100-00-1D-00-00-02Status[ENABLED][ENABLED][ENABLED][DISABLED]Switch Address: 00-00-1D-00-00-00Number of Ports: 4Type of STA: [IEEE]Age Time (sec): 300EXIT
