4. Press the pushbutton under the desired SpeedCompensated Volume setting (OFF, Low, Med,or High) to select the level of radio volumecompensation. The display times out afterapproximately 10 seconds. Each higher settingallows for more radio volume compensation atfaster vehicle speeds.AudioPilot® : If your vehicle has the Bose® audiosystem, it has AudioPilot ® noise compensationtechnology.To use AudioPilot ®, do the following steps:1. Set the radio volume to the desired level.2. Press the MENU button to display the radiosetup menu.3. Press the pushbutton located under theAUTO VOLUM label on the radio display.4. Press the ON or OFF button to turn this featureon or off.When turned ON, AudioPilot ® continuously adjusts theaudio system equalization, to compensate forbackground noise, so that your music always soundsthe same at the set volume level.The feature is most effective at lower radio volumesettings where background noise can affect how wellyou hear the music being played through your vehicle’saudio system. At high volume settings there might be littleor no adjustments by AudioPilot® . For more informationon AudioPilot ®, visit www.bose.com/audiopilot.Finding a StationBAND: Press to switch between AM, FM, or XM™(if equipped). The selection displays.a (Tune): Turn to select radio stations.©SEEK ¨: Press the arrows to go to the next orto the previous station and stay there.To scan stations, press and hold either arrow forthree seconds until a beep sounds. The radio goesto a station, plays for a few seconds, then goes to thenext station. Press either arrow again to stop scanning.The radio only seeks and scans stations with astrong signal that are in the selected band.4 (Information) (XM™ Satellite Radio Service,MP3/WMA, and RDS Features): Press this buttonto display additional text information related to thecurrent FM-RDS or XM™ (if equipped) station, orMP3/WMA song. A choice of additional information suchas: Channel, Song, Artist, CAT (category) can display.Continue pressing the information button to highlightthe desired label, or press the pushbutton positionedunder any one of the labels and the informationabout that label displays.When information is not available, No Info displays.3-101
