Testing the AlarmTo test the alarm:1. From inside the vehicle, lower the driver’s windowand open the driver’s door.2. Activate the system by locking the doors with thepower door lock switch while the door is open, orwith the RKE transmitter.3. Get out of the vehicle, close the door and wait forthe security light to go out.4. Then reach in through the window, unlock the doorwith the manual door lock and open the door.This should set off the alarm.While the alarm is set, the power door unlock switch willnot work.If the alarm does not sound when it should but theheadlamps flash, check to see if the horn works.The horn fuse may be blown. To replace the fuse,see Fuses and Circuit Breakers on page 6-106.If the alarm does not sound or the headlamps donot flash, the vehicle should be serviced by yourdealer/retailer.PASS-Key® III+ ElectronicImmobilizerThe PASS-Key III+ system operates on a radiofrequency subject to Federal CommunicationsCommission (FCC) Rules and with Industry Canada.This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:1. This device may not cause harmful interference.2. This device must accept any interference received,including interference that may cause undesiredoperation.This device complies with RSS-210 of Industry Canada.Operation is subject to the following two conditions:1. This device may not cause interference.2. This device must accept any interference received,including interference that may cause undesiredoperation of the device.Changes or modifications to this system by other thanan authorized service facility could void authorization touse this equipment.PASS-Key III+ uses a radio frequency transponder inthe key that matches a decoder in the vehicle.2-22
