User Manual – Rev AJ California Instruments4.2.11.3 INITIAL SETUP menuFigure 4-23: INITIAL SETUP MenusAny time the power source is powered up, the output will reflect the values stored as the INITIAsetup values. This allows the unit to be powered up in a known state at all times. The INITIALLvoltage present at the output. For commended due to theoutput relay be programmed to OThe following fields are provided in the INITIAL SETUP menus:values can be set in the INITIAL SETUP menus.The initial setup can be used to power up the power source with the output on and a highnormal situations, this is not repotential danger to the operator. It is recommended that the initial voltage be set low and/or theFF for most situations.Entry DescriptionINITIAL SETUP 1Sets the power-on AC voltage for AC and AC+DC mDC voltage for DC mode.VOLTAGE odes or theIMITFREQGEVOLT MODEilablesettings are Internal (INT) or External (EXT).CURR L Sets the power-on current limit value.Sets the power-on frequency value.PHASE Sets the power-on frequency for phase A with respect to anexternal sync signal. If the internal oscillator is used (default)this setting has no effect.INITIAL SETUP 2VOLT RAN Sets the power-on voltage range value.Sets the power-on voltage mode. Available settings are ACmode, DC mode or AC+DC mode.OL MODE Sets the power-on overload mode. Available settings areConstant Current (CC) or Constant Voltage (CV) mode.OUTPUT RELAY Sets the power-on state of the output relay. Available settingsare ON or OFF.INITIAL SETUP 3VOLT SENSE Sets the power-on state of the voltage sense mode. AvaMX Series 111
