User Manual – Rev AJ California Instruments3.7.7 LAN Interface – RJ45An optional RJ45 Ethernet 10BaseT connector is located on the rear panel for remote control.standard RJ45 UTP patch cord between the AC Source and a network Hub may be used toconnect the AC source to a LAN. For direct connection to a PAC LAN card, a crossover RJ45cetion is present, the MAC Address (Media Access Control) of theEthern erear paconnection using the LANinterface, refer to the MX Series Programming Manual P/N 7003-961 distributed in Adobe PDFformat on CD ROM CIC496.cable is required. Consult your network administrator for directions on connecting the AC sourto any corporate LAN.If the –LAN Ethernet interface opet port is printed on the serial tag of the power source. The serial tag is located on thnel of the unit.For information on how to set up a network connection or a direct PCLANPin Ethernet TPE10BaseT/100BastT/1000BaseTEIA/TIA 568A EIA/TIA 568BCrossover1 Transmit/Receive Data 0 + White with green stripe White with orange stripe2 Transmit/Receive Data 0 - Green with white stripe orsolid greenOrange with white stripe orsolid orange3 Transmit/Receive Data 1 + White with orange stripe White with green stripe4 Transmit/Receive Data 2 + Blue with white stripe orsolid blueBlue with white stripe orsolid blue5 Transmit/Receive Data 2 - White with blue stripe White with blue stripe6 Transmit/Receive Data 1 - Orange with white stripeor solid orangeGreen with white stripe orsolid7 Transmit/Receive Data 3 + White with brown stripe orsolid brownWhite with brown stripe orsolid brown8 Transmit/Receive Data 3 - Brown with white stripe orsolid brown.Brown with white stripe orsolid brownTable 3-12: RJ45 LAN Connector pin out.MX Series 61
