User Manual - Rev AJ California InstrumentsFigure 9-33: MIL704 Menu9.6.1.6 Revision SelectionThe default Rethe front panel. Scroll to the REVISION entryvision is E. Revisions supported are D and E. The Revision can be changed fromusing the up and down cursor keys (see Figure9.6.1.7 AC MODE TESTS9-33). Use the shuttle to change the selection.9.6.1.7.1 Steady State TestScroll to the STEADY STATE AC entry using the up and down cursor keys. Press the ENTERkey to select the STEADY STA e appear as shown in Figure 9-34.TE scre ns. The screen willFigure 9-34: Steady State MenuThe MIL704 Steady state 1 and Steady state 2 screens have the following tests:1 VOLTAGE2 FREQUENCY3 VOLT UNBALANCEOLT MODULATIONFREQ MODULATIONdownVOLTAGEThis test will change the output voltage in the following sequence:• 118V for 1 minute.e.The ← key (backspace) will terminate the test at any time.4 PHASE DIFFERENCE5 V67 DISTORTIONThe above tests can be selected by scrolling to the highlighted selection using the up andcursor keys and the ENTER key to start the selected test.• 108V for 1 minute.• 115V for 1 minutMX Series 227
