User Manual – Rev AJ California Instruments4.3 Output Programming4.3.1 Set the OutputOutput parameters are all set from the PROGRAM screen.1. Use the MENU key and select the PROGRAM entry.2. Press the ENTER key to bring up the PROGRAM menu.or2. Use the PROG key to directly bring up the PROGRAM menu.There are two methods for programming output parameters:IMMEDIATE modeSET mode4.3.2 Slewing Output Values with the Knob in IMMEDIATE ModeThe default mode of operation is an immediate mode in which changes to output parametersmade with the knob or the entry keypad are immediately reflected at the output.To change the output voltage:CounterClockwiseClockwiseINCRDECR1. Place the cursor on the VOLTAGE entry2. Rotate the knob clockwise to increase the value, counterclockwise to decrease the valueThese changes take effect immediately.To change the output frequency:CounterClockwise wiseINCRDECRClock1. Place the cursor on the FREQ entry2. Rotate the knob clockwise to increase the value, counterclockwise to decrease the valueThese changes take effect immediately.MX Series 119
