Control PanelPaper DetailsSetting Item Description, InstructionsRoll DryingTime Specify the time to wait for the ink to dry for each sheet.Scan Wait Time Specify the time to wait for the ink to dry between each scan inbidirectional printing, in consideration of how quickly the inkdries. Note that printing will take longer if you specify a wait time.Feed Priority Specify exact paper feeding, if desired. Normally, selectAutomatic. Choose Print Length if you prefer to feed thepaper an exact amount. However, note that choosing PrintLength may result in slight banding in the direction of Carriagescanning.Adjust Length Displayed if Feed Priority is Print Length.Adjustment relative to the amount of stretching or shrinkage ofthe current paper.Enter either the adjustment results from Print Pattern or thediscrepancy that you measured (as a percentage).For paper that tends to stretch, increase the feed amount bychoosing a higher adjustment value. For paper that tendsto shrink, decrease the feed amount by choosing a loweradjustment value.Head Height Adjust the Printhead height. (→P.653)Skew Check Lv. If you print on Japanese paper (washi) or other handmadepaper that has an irregular width, choose Loose for a higherskew detection threshold, or choose Off to disable skewdetection. However, if paper is loaded askew when detection isOff, note that paper jams or Platen soiling may occur.VacuumStrngth Specify the level of suction that holds paper against the Platen.(→P.660)Width Detection When this setting is set to Off , the printer prints withoutdetecting the paper width. Specify Off when printing at a widthdifferent from the paper width.NearEnd RollMrgn Specify the minimum margin at the leading edge of roll paper toensure better printing quality at the leading edge.Note that if you choose 5mm , it may lower the printing qualityat the leading edge and affect feeding accuracy. The printedsurface may be scratched, and ink may adhere to the leadingedge. It may also cause the Platen to become soiled.Cut Speed Choose the cutting speed. If you use adhesive paper, choosingSlow helps prevent adhesive from sticking to the cutter andkeeps the cutter sharp.Trim Edge First If a roll is loaded, the end of the paper will be cut.(The paper type isdisplayed here.)(*1)Cutting Mode Specify whether or not to cut with the standard round-bladedcutter.Choose Automatic to have the roll cut automatically afterprinting. If you choose Manual, the paper will not be cut afterprinting. Instead, a line will be printed at the cut position.Choose Eject if you prefer not to have documents droppedimmediately after printing, as when waiting for ink to dry.Printer Parts 51
