Messages regarding printing or adjusmentMessages regarding printing or adjusmentUse another paper.Cause Corrective ActionWe recommend using a type of paper that you oftenuse, other than lm, for Printhead adjustment.(→P.649)The Printhead and feed amount cannot be adjustedwhen highly transparent lm is loaded.Adjust the feed amount manually.(→P.657)Cannot execute this command. Use other paper.Cause Corrective ActionThe loaded paper cannot be used for color calibration. Load paper compatible with color calibration.*1 See"Paper Reference Guide ." (→P.169)*1: Always make sure the loaded paper matches the media type setting on the printer. Adjustment cannotbe completed correctly unless the setting value matches the loaded paper.Cannot print as specied.Lift the release lever and replace paper with A4/LTR (vertical) or largerCause Corrective ActionThe loaded paper is too small. Switch to paper A4/Letter (vertical) or larger.Lift the release lever and replace roll with 10 in. wide or larger rollCause Corrective ActionThe loaded paper is too small. Load a roll 10 inches wide or larger.Cannot adjust band.Cause Corrective ActionThe Printhead nozzles are clogged. Follow the steps below to check the nozzles.1.Print a test pattern to check the nozzles.(→P.692)2.Clean the Printhead if the nozzles are clogged.(→P.693)Highly transparent lm is loaded that cannot be usedfor feed amount adjustment.Adjust the feed amount manually.(→P.657)Error Message 777
