PrintheadsReplacing the PrintheadFollow the steps below to replace the Printhead. Failure to follow this procedure may cause ink to leakfrom the Printhead, resulting in stains.Only remove or install the Printhead after selecting Replace P.head in the menu, and follow the instructionson the panel. Removing or installing the Printhead without following the correct procedure may damage thePrinthead.Note• Prepare a new Ink Tank when ink levels are low.• Your hands may become dirty during Printhead replacement. During replacement, wear the glovesprovided with the new Printhead.• Choose On in Auto Print to have the printer automatically adjust the Printhead alignment afterPrinthead replacement. (→P.49)1. If the roll is not ejected because of the cutting method selected, cut it manually and remove it.(→P.486)2. Clean inside the Top Cover. (→P.717)3. Press the Menu button to display MAIN MENU.4. Press ▲ or ▼ to select Maintenance, and then press the ► button.5. Press ▲ or ▼ to select Replace P.head, and then press the ► button.6. Press ▲ or ▼ to select Yes, and then press the OK button.Select Printhead L when replacing Printhead L and Printhead R when replacing Printhead R.When replacing both, select L & R Printheads. Be sure to specify the correct Printhead.Ink is now absorbed.After about three minutes, a message is shown on the Display Screen instructing you to openthe Top Cover.7. Open the Top Cover.Instructions are now shown on the Display Screen regarding Printhead replacement.Maintenance 695
