|
2-16Loading PaperOriginals and Print MediaIn the Stack Bypass TrayIf you are making prints on transparencies, labels, nonstandard-sized paper, or envelopes, load them into thestack bypass tray.Note the following points when using the stack bypass tray:Paper Quantity: one to approximately 100 sheets (20 lb (75 g/m2),)Paper Size: 3" × 5" to 8 1/2" × 14" (76.2 × 127 mm to 216 × 356 mm )Paper Weight: 16 to 47 lb (60 to 176 g/m2)Paper which has been rolled or curled must be straightened out prior to use, to allow the paper to feed smoothly through the stackbypass tray (allowable curl amount: less than 3/8" (10 mm) for normal paper, less than 1/4" (5 mm) for heavyweight paper).Depending on the paper storage conditions, it may not be possible to feed some paper into the stack bypass tray. In this case, setthe amount of paper to less than 50 sheets 20 lb (75 g/m2).Do not load different size/type paper at the same time.If you load multiple sheets of heavyweight paper into the stack bypass tray, a paper jam may occur depending on the type ofheavyweight paper. If this happens, load only one sheet of heavyweight paper at a time.When printing on special types of paper, such as heavyweight paper or transparencies, make sure to correctly set the paper type,especially if you are using heavyweight paper. If the type of paper is not set correctly, it could adversely affect the quality of theimage. Moreover, the fixing unit may become dirty and require a service repair, or the paper could jam.If you are printing on envelopes, do not allow more than 10 envelopes to accumulate in the output tray. Always empty the outputtray once 10 envelopes have accumulated.If you select for copying, you cannot use the 1-Sided to 2-Sided, 2-Sided to 2-Sided, N on 1, or ID Card Copy mode.(See “Copy,” in the e-Manual.)If you select , , , , for copying, you cannot use the 1-Sided to 2-Sided, 2-Sided to 2- Sided, N on 1, or ID Card Copy mode. (See “Copy,” in the e-Manual.)You cannot use when you print from a USB memory (Direct Print). (Only for the Color imageCLASS FM9280Cdn)Envelopes may be creased in the printing process.For high quality printouts, use paper recommended by Canon.For more information on paper types that can be used with this machine, see “Paper Requirements,” on p. 2-7.–•••••–––––––––– PreviousNext |