3263 Custom Function SettingsSpot metering linked to AF pointYou can enable or disable AF point-linked spot metering in the <r>metering mode.Center AF point onlyRegardless of the AF point currently selected, spot metering will alwaysbe linked to the viewfinder’s center AF point.Linked to active AF pointSpot metering will be linked to the manually-selected AF point. If the AF areaselection mode is set to 61-point automatic selection or Zone AF (automaticZone selection), spot metering is performed at the viewfinder center.Safety shiftOFF: DisableTv/Av: Shutter speed/ApertureThis function takes effect in the shutter-priority AE (s) and aperture-priority AE(f) modes. If the subject’s brightness changes and the standard exposurecannot be obtained within the autoexposure range, the camera will automaticallychange the manually-selected setting to obtain a standard exposure.ISO: ISO speedThis function takes effect in the Program AE (d), shutter-priority AE(s), and aperture-priority AE (f) modes. If the subject’s brightnesschanges and the standard exposure cannot be obtained within theautoexposure range, the camera will automatically change the manuallyset ISO speed to obtain a standard exposure.If the safety shift automatically sets ISO 32000 or higher (when the camera’sinternal temperature is low, ISO 20000 or higher), when [ISO speed] is set, themaximum continuous shooting speed at <o> will be approx. 10 shots/sec.Under [z2: ISO speed settings], even if [ISO speed range] or [Min.shutter spd.] is changed from the default setting, safety shift willoverride it if a standard exposure cannot be obtained.The minimum and maximum sensitivities of the safety shift using the ISOspeed will be determined by the [Auto ISO range] setting (p.131).However, if the manually set ISO speed exceeds the [Auto ISO range],the safety shift will extend up to the manually set ISO speed.If [Shutter speed/Aperture] or [ISO speed] is set, safety shift will takeeffect if necessary even when flash is used.COPY
