123456789Back NextPreviousTOP8-30Before Using theMachineDocument and PaperSending andReceivingCopyingPrintingSystem ManagerSettingsMaintenanceTroubleshootingAppendixIndexTable of ContentsCopying ProblemsBlank paper comes out from the machine.Have you removed the plastic seal from the tonercartridge?Make sure you remove the seal from the cartridge.(See “Set Up the Machine,” in the Starter Guide.)Is the toner cartridge installed properly?Make sure the toner cartridge is installed properly.(See “Set Up the Machine,” in the Starter Guide.)Is the cartridge out of toner?Replace the toner cartridge. (See “Replacing the TonerCartridge,” on p. 7-8.)Does the document meet the requirements for themachine?Make sure you load documents that meet therequirements for use. (See Chapter 2, “DocumentRequirements,” on p. 2-2.)QAQAQAQACopy is too light or has uneven density.Is the toner low or unevenly distributed?Redistribute the toner inside the toner cartridge. Ifthe problem persists, replace the toner cartridge. (See“Replacing the Toner Cartridge,” on p. 7-8.)Copy has vertical white streaks.Is the toner low or unevenly distributed?Redistribute the toner inside the toner cartridge. Ifthe problem persists, replace the toner cartridge. (See“Replacing the Toner Cartridge,” on p. 7-8.)Copy is spotted or dirty.If the copy is spotted or dirty, clean the scanningcomponents and machine’s interior (See “Cleaning theMachine,” on p. 7-2.)QAQAA
