Setting Up YourLASER CLASS2060PChapter 2 Setting Up Your LASER CLASS 2060P 2-21Connecting the LASER CLASS 2060P to Your PCYour LASER CLASS 2060P has an 8-bit, bi-directional parallel interfaceport that allows you to connect it to a PC. To do this, you need topurchase a Centronics-compatible parallel interface cable from yourdealer.For best results, use a cable that is no longer than 6.6 feet (2 meters).Canon recommends that you use a cable that complies with IEEE 1284.Contact your local authorised Canon Facsimile Dealer if you need help inselecting a cable.Connect the LASER CLASS 2060P to your computer as follows:1. Make sure the computer is turned off and the LASER CLASS 2060P isunplugged.2. Connect the parallel interface cable to your LASER CLASS 2060P:a. Align the cable connector with the interface port so their shapesmatch.b. Gently press the cable connector into the port.c. Secure the cable connector by snapping both wire clips (on thesides of the port) into the cable connector, as shown below.3. Connect the other end of the cable to the parallel interface port onyour computer in the same manner.N
