Settings Menu3-243Printer Settings Menu■ Offset Short Edge/Offset Long Edge (Front)-2.00 to +2.00 inches (in increments of 0.01 inches); 0.00* inchesThis setting enables you to set the offset position. The settings can be set inincrements of 0.01" (0.5 mm) from -2.00" (-50.0 mm) through +2.00" (+50.0 mm).The print position on the front page is adjusted in the vertical or horizontaldirection to the value specified in the setting value.To adjust the print position on the back page, set 'Offset Short Edge/Offset LongEdge (Back)' (the next setting).You can increase or decrease the setting in increments of 0.01" (0.5 mm) toadjust the print position, as described below.Offset Short Edge (Front): Increasing the setting value moves the image in therightward X direction on the paper. Decreasing the setting value moves the imagein the leftward X direction on the paper.Offset Long Edge (Front): Increasing the setting value moves the image in thedownward Y direction on the paper. Decreasing the setting value moves theimage in the upward Y direction on the paper.IMPORTANTPlease note that if the print position is adjusted to place print data outside theprintable area, the portion outside the printable area is not printed.NOTE• If this setting is used in combination with 'Margin', the values of the two settings areadded together.• Pressing [ ] increases the setting value by 0.01" (0.5 mm) each time the key ispressed. Pressing [ ] decreases the value by 0.01" (0.5 mm) each time. Holdingdown either [ ] or [ ] continuously speeds up the value alteration.ABCXYAdjust usingX/Y-AdjustmentArea adjusted usingY-Adjustment[+]Area adjusted usingX-Adjustment[+]Front FrontABCPart of theoriginal margin
