Preface XIII• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.• Consult the dealer or an experienced radio/TV technician for help.Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of the FCCRules.Do not make any changes or modifications to the equipment unless otherwise specified in thisguide. If such changes or modifications should be made, you could be required to stopoperation of the equipment.Canon U.S.A. Inc.One Canon Plaza, Lake Success, NY 11042, U.S.A.TEL No. (516) 328-5600The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use acomputer or other electronic device to send any message via a telephone fax machine unlesssuch message clearly contains in a margin at the top or bottom of each transmitted page or onthe first page of the transmission, the date and time it is sent and an identification of thebusiness or other entity, or other individual sending the message and the telephone number ofthe sending machine or such business, other entity, or individual.To automatically enter this information into your machine, follow the instructions on p. 7-1 orp. 8-1 of this guide. Users in CanadaPre-installation requirements for Canon facsimile equipmentA. LocationSupply a suitable table, cabinet, or desk. See the Appendix for the machine’s dimensions andweight.B. Order information1. Provide only a single-line to touch-tone or rotary telephone set terminated with a standard4-pin modular phone plug. (Touch-tone is recommended if available in your area.)2. Order an RJ11-C modular jack (USOC code), which should be installed by the telephonecompany. If the RJ11-C jack is not present, installation cannot occur.3. Order a normal business line from your telephone company’s business representative. Theline should be a regular voice grade line or equivalent. Use one line per machine.DDD (DIRECT DISTANCE DIAL) LINE-or-IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU COMMUNICATE OVERSEASNOTE• Canon recommends an individual line following industry standards [e.g., the 2500 (touch tone) or 500(rotary/pulse dial) telephones]. A dedicated extension off a PBX unit without “Camp On” signals is alsopermissible with your MultiPASS MP730. Key telephone systems are not recommended because theysend non-standard signals to individual telephones for ringing and special codes, which may cause a faxerror.
