Canon Legria HF R47 Instruction Manual

Also see for LEGRIA HF R406: Instruction manual Quick guide

Contents

168 Additional InformationNo access points found- The access point set in the camcorder could not be found.- Cordless phones, microwave ovens, refrigerators and other appliances may interfere with thewireless signal. Try using the camcorder in a location farther away from such appliances.- Make sure that you use the access point’s SSID for the camcorder’s Wi-Fi settings (A 136).- If the access point is using MAC address filtering, enter the camcorder’s MAC address in theaccess point’s configuration screen.Unable to access configuration files- Turn off the camcorder. After a short while, turn it on again. If the problem persists contact aCanon Service Center.Unable to complete WPS. Try the operation again.- Some wireless routers require pressing and holding the Wi-Fi Protected Setup (WPS) button.For details, refer to the instruction manual of your wireless router.- Make sure to touch [OK] on the camcorder’s screen within 2 minutes of activating the Wi-FiProtected Setup signal on the wireless router, whether by pressing the button or by enteringthe PIN code.Unable to complete WPS.- Turn off the camcorder and wireless router. After a short while, turn them on again and tryagain. If the problem persists, perform setup using the [Search for Access Points] option(A 134).Unable to connect- Cordless phones, microwave ovens, refrigerators and other appliances may interfere with thewireless signal. Try using the camcorder in a location farther away from such appliances.Unable to obtain an IP address- If you are not using a DHCP server, connect using the [Manual Setup] option and enter the IPaddress using the [Manual] option (A 137).- Turn on the DHCP server. If it is already on, make sure it is functioning properly.- Make sure the address range for the DHCP server is sufficient.- Turn on the DNS server. If it is already on, make sure it is functioning properly.- Make sure that the DNS server’s IP address and the name for that address are correctly configured.- Set the DNS server’s IP address in the camcorder.- If you are not using a DNS server, set the DNS address to [0.0.0.0].- If you are using a wireless gateway router, make sure all of the devices in the network, includ-ing the camcorder, are configured with the correct gateway address.Wi-Fi authentication unsuccessful- Make sure the camcorder and access point are using the same authentication/encryptionmethod and encryption key.- If the access point is using MAC address filtering, enter the camcorder’s MAC address in theaccess point’s configuration screen.COPYDownloaded From VideoCamera-Manual.com Manuals