Canon MV MVX2i Instruction Manual

Contents

2EIntroductionImportant Usage InstructionsCAUTION:CUSTOMERS IN THE U.K. SHOULD READ THIS BEFORE USING THIS PRODUCT.CHANGING THE FUSETHE MAINS LEAD ON THIS PRODUCT IS FITTED WITH A NON-REWIREABLE (MOULDED) PLUG,INCORPORATING A 3 AMP FUSE. SHOULD THE FUSE NEED TO BE REPLACED AN ASTA OR BSIAPPROVED BS1362 FUSE OF THE SAME RATING MUST BE USED.ALWAYS REFIT THE FUSE COVER AFTER REPLACING THE FUSE. NEVER USE THE PLUG WITHTHE FUSE COVER OMITTED.CHANGING THE PLUGIF THE FITTED PLUG IS NOT SUITABLE FOR YOUR SOCKET OUTLETS, IT SHOULD BE CUT OFFAND AN APPROPRIATE PLUG FITTED IN ITS PLACE. IF POSSIBLE FIT AN APPROPRIATE 3 AMPFUSE. IF THE NEW PLUG HAS NO FUSE, THEN FIT A 5 AMP FUSE AT THE DISTRIBUTIONBOARD.AC POWER CORD CONNECTIONThe wires in the mains lead of this apparatus are coloured in accordance with the followingcord.(IMPORTANT)As the colours of the wires in the mains lead may not correspond with the coloured markingsidentifying the terminals in your plug, proceed as follows: The wire which is coloured BLUEmust be connected to the terminal which is marked with the letter N or coloured black. Thewire which is coloured BROWN must be connected to the terminal which is marked with theletter L or coloured red. Neither Blue wire or Brown wire is to be connected to the Earth pin ofa 3 pin plug.THE SEVERED PLUG MUST BE DESTROYED IMMEDIATELY TO AVOID ANY POSSIBLE ELECTRICSHOCK HAZARD.Mains Lead BLUE ....................NEUTRALBROWN. ..............LIVEWARNING:TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICEPERSONNEL.WARNING:TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THISPRODUCT TO RAIN OR MOISTURE.CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK AND TO REDUCE ANNOYINGINTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY.CAUTION:DISCONNECT THE MAINS PLUG FROM THE SUPPLY SOCKET WHEN NOT IN USE.For Users in the UKWhen replacing the fuse only a correctly rated approved type should be used and be sure to re-fitthe fuse cover.• Use of CV-150F/CV-250F DV cable is necessary to comply with the technical requirement of EMCDirective.CA-560 identification plate is located on the bottom.