89EEditing1. Connect the camcorder to the VCR.• See “Connections for Playback on a TV Screen” on p. 34.2. Prepare the TV and VCR.• Turn on the TV and set the TV/VIDEO selector to VIDEO.• Turn on the VCR, and set its input selector to LINE. Load a blankcassette, and put the VCR in record pause mode.• See your TV and VCR instruction manuals for details.3. Turn the camcorder’s POWER switch to PLAY (VCR), and movethe camcorder’s TAPE/CARD switch to TAPE.• Make sure the AV/headphone terminal is set to AV through the menu( 34). If PHONES appears in the display, switch the terminal.4. Load your recorded cassette.Editing to a VCR1. Find a point on your recorded cassette slightly before thesection you wish to copy.2. Start to play it back while you monitor the picture on the TV.3. Start recording on the VCR as soon as the section you wishto copy appears on the screen.4. Pause the VCR at the end of the section you wish to copy,then stop playback on the camcorder.5. Repeat steps 1 to 4 until your edited recording is complete.Note:• The quality of the edited tape will be slightly lower than that of the original.By connecting the camcorder to a VCR, you can edit your recordings in orderto remove unwanted scenes — or combine different shots to create yourown video productions.The m terminal allows you to connectthe camcorder to equipment. Somebuttons on editing equipment mayoperate differently from those on thecamcorder.PreparationsEditingm (LANC) TerminalNotes:• m (LANC) is a trademark. It stands for Local Application Control Bus System.• We cannot guarantee the results when connecting to equipment notbearing the LANC m symbol.
