Chapter 8 Troubleshooting 8-13Message Error Code Cause ActionMEMORY FULL #037 The memory of the Print out any documentsMultiPASS is full that are stored inbecause it has received memory. Then start thetoo many documents, operation again.or a very long ordetailed document.Memory is full because Divide the documentyou tried to send too and send each partmany pages at once, separately.or a very long ordetailed document.MEMORY FULL — The MultiPASS is If sending a fax, thePLEASE WAIT sending a fax and its MultiPASS continues tomemory is full. send the fax as memorybecomes available.MEMORY USED nn% — Shows the percentage of If you need more space,memory currently in use. print or send anydocuments in memory.NO ANSWER #005 The receiving fax Make sure you dialedmachine does not the correct number.answer. Try again later.NO RX PAPER #012 The other party’s fax is Contact the other partyout of paper or its and have them installmemory is full. paper in their fax.NO TEL # #022 The one-touch or coded Register the numberspeed dialing number (see page 3-14).has not been registered.NOT AVAILABLE NOW #025 In manual sending, you Use regular dialing.entered a speed dialingnumber that is assignedto a group.PLEASE WAIT — The MultiPASS is Wait until the date andwarming up. Receive Mode appear inthe LCD display, thenbegin.PUT IN CARTRIDGE — The BJ cartridge is Make sure the BJnot properly installed. cartridge is installedcorrectly and the greenlock lever is down.Troubleshooting
