Chapter 4 Sending Faxes With the MultiPASS C635 4-7If there is no group registered under the one-touch speed dialing buttonor the two-digit code, the LCD displays the NO TEL # message. Makesure you entered the correct number and that the group has beenregistered correctly to a speed dial code. (See “Defining a Group SpeedDial Code” in Chapter 3, Using the MultiPASS Fax Setup Utility.)If you make a mistake when dialing, press STOP. You can then try again.RedialingManualTo start dialing again, just press REDIAL. The MultiPASS redials theprevious number you dialed with the numeric buttons. Make sure thedocument is in the ADF.AutomaticThe MultiPASS automatically redials if the first attempt at sending fails(for example, if the line is busy). The unit redials twice, and the timebetween redials is two minutes. (These are the default settings.) TheLCD displays AUTO REDIAL and the transaction number while theMultiPASS is redialing.If the MultiPASS fails to make a connection after the last redial, itbeeps. The LCD displays BUSY/NO SIGNAL; try sending again later.You can change the number of redials (retries) and the time betweenredials. The redialing options are set in the Send Fax panel of theMultiPASS Fax Setup Utility; see “Setting Up Send Fax Options” inChapter 3, Using the MultiPASS Fax Setup Utility.BUSY/NO SIGNALTX/RX NO. XXXXAUTO REDIALSending Faxes
