AdditionalInformationE118Refer to page 87.Appears when you try to doaudio dubbing or AV insert on atape recorded in any mode otherthan SP mode(p. 37).Appears when you try to doaudio dubbing on a taperecorded in 16-bit audio or 12-bit 4-channnel mode (p. 88).Appears when the cameradetects a blank section of a tapeduring audio dubbing or AVinsert (p. 91).Appears immediately after youstart recording, and the videoheads are badly contaminated.Make sure to clean the videoheads when this caution appears(p. 105).SET THE TIME ZONE,DATA AND TIMECHECK THE LENSTER I NGEN ”PO ERW TANDBY”SCHANGE THE BATTERY PACKCHECK THE DV NPUTITAPE ENDE TAPE I SERTHASET FORURS E PRE ENV T I ONCONDENSAT I ONHAS BEEN DET CTEDEREMOVE THE CAS ETTESR ECOPY DPROTECTCTEDR I GHTPLAYBACK I S STR IER ECOPY DPROTECTCTEDR I GHTDUBB I NG STR IECHECK THE CASSETTE[REC MODE]CHECK THE CASSETTE[AUDIO MODE]CHECK THE CASSETTE[BLANK]HEADS DIRTY,USE CLEANING CASSETTECaution phrasesThe camera displays various caution phrases —they appear for 4 seconds before disappearing.Appears each time you turn thepower on, until you set the timezone, date and time (p. 32).Refer to pages 14-15.Refer to page 35.Appears when the battery packis exhausted (p. 20, 98).Appears when the tape hasreached the end.Refer to page 23.Appears when you press the 2(record) button if the DV cableis not connected properly(p. 65).Refer to page 106.Appears as a warning to protectthe tape and also whencondensation is detected.Remove the tape as soon aspossible after the camera hasdisplayed the caution.Refer to page 87.
