EditingE94PreparationsTurn the camera’s POWER dial to VCR. Load a recorded cassette.• Make sure the REC/SAVE tab on the cassette has been slid to REC (closed position).DubbingDo not connect/disconnect any cables to/from the camera when dubbing audio or preparing to dub audio.• Step 1 and 2 are the same operations as 2 Channel Recording.1. Slide the INPUT SELECT switch to your input (MIC or AUDIO 1).• When you use the AUDIO 1, select the input level from the AUDIO 1 IN of VCR SET UP of cameramenu.2. Adjust the recording level.3. Locate the point where you want to start audio dubbing, then press the PAUSE button.• You can use the playback buttons on the body of the camera or the special playback functions on thewireless controller in the same way as in playback mode.• The camera becomes set to playback pause mode.4. Press AUDIO DUB.• AUDIO DUB. and appear on the viewfinder.5. Press the PAUSE button on the wireless controller or play pause e/a button(and startplay on the other audio device if AUDIO 1).• Audio dubbing starts.• If you are using the microphone, direct your voice into the microphone.• changes to .AUDIOMONITERRECPAUSEAUDIODUB.SEARCH SELECTMIXBALANCEST-2ST-1REWPAUSE SLOWPLAYSTOPFF2+POWERVCROFFTvAvARECAUDIO DUB.AV INSERTAUDIO 1 IN•• LINEVCR SET UP(see p. 26)
