Canon ZR80 Instruction Manual

Also see for ZR80: Instruction manual Instruction manual Brochure

List of MessagesMessage Explanation [3_JSETTHE TIME ZONE, You have not set the time zone, date and time. This message 21DATE AND TIME appears each time you turn the power on until you set thetime zone, date and time.CHANGE THE Battery pack is exhausted. Replace or charge the battery 13BATFERY PACK _ack.THE TAPE IS SET FOR Cassette is protected. Replace the cassette or change the 138ERASURE PREVENTION )osition of the protect switch.REMOVE THE Camcorder stopped operating to protect the tape. Unload 16CASSETTE and reload the cassette.CHECK THE DV INPUT DV cable is not connected, or the connected digital device is 80turned off.CONDENSATION HAS Condensation has been detected in the camcorder. 136BEEN DETECTEDTAPE END Tape reached the end. Rewind the tape or replace the -cassette.CHECK THE CASSEqq-E You attempted to perform audio dubbing or AV insert on a 86[REC MODE] tape recorded in a mode other than the SP mode. 88CHECK THE CASSETTE You attempted to perform audio dubbing on a tape 88[AUDIO MODE] recorded in 16-bit or 12-bit 4-channel sound.CHECK THE CASSETTE You attempted to perform audio dubbing or AV insert on a 86[BLANK] tape with a blank section. 88COPYRIGHTPROTECTED You attempted to play back a copyright protected tape. 83PLAYBACKISRESTRICTEDCOPYRIGHT You attempted to dub a copyright protected tape. May also 83PROTECTED DUBBING appear when an anomalous signal is received during analogRESTRICTED line-in recording, or during analog-digital conversion of acopyright protected tape.131