Chapter 1414-17T-14-28Cause: After transmission of the Q signal following the image signal, theline condition became poor so that the other party cannot receivethe image signal or the Q signal correctly.Remedy: 1. Increase the transmission level so that the other party mayservice the image signal or the Q signal correctly.2. Decrease the transmission start speed.3. Adjust the NL equalizer so that the other party may receive theimage signal or the Q signal correctly.4. Add an echo protect tone to the V.29 modem signal fortransmission.5. Increase the number of final flag sequences for the proceduresignal so that the other party may receive the procedure signalcorrectly.##101 [TX/RX] The modem speed of the machine does not match that of theother partyCause: The modem speed of the machine does not match that of the othermachine.Remedy: The modem speed is part of machine specifications, and there isno remedy.Cause: In the case of transmission, the speed for fallback does not matchthat of the other party.Remedy: 1. Increase the transmission level so that the other party mayreceive TCF correctly.2. Adjust the NL equalizer so that the other party may receive TCFcorrectly.3. Provide echo remedy 1.4. Using a manual call, press the Start button after hearing the 1stDIS from the other party.5. To prevent response to the 1st DIS from the other party, put arelatively long pause to the telephone number when registering anauto-dialing number.6. Ask the operator of the other party to decrease the transmissionlevel so that the other party will not receive an echo.##100 [TX] The number allowed for retransmission of the proceduresignal was exceeded during transmission
