Chapter 1414-34T-14-70T-14-71Remedy: Transmit once again.##758 [TX] In ECM transmission, the allowed number of proceduresignal re-transmissions was exceeded or a T5 time-over(60 sec) condition occurred after transmission of PPS-MPSCause: The page buffer of the other party is full or is engaged; as such,although RNR was received after transmission of PPS-MPS andthen RR was transmitted, no significant signal was receivedcorrectly thereafter.Remedy: 1. Start G3 mode, and transmit once again (Prohibit the ECMmode).2. Decrease the transmission start speed.3. Record the protocol on a DAT or MD, and have it analyzed bythe local Canon office and/or Technical Center.##759 [TX] In ECM transmission, the allowed number of proceduresignal retransmissions was exceeded after transmissionof PPS-MPSCause: The line condition is poor; as such, although PPR was received 4times after transmission of PPS-MPS and then CTC wastransmitted, the other party could not receive it correctly.Remedy: Increase the transmission level so that the other party may receiveCTC correctly.Cause: The line condition is poor; as such, although PPR was received 4times after transmission of PPS-MPS and then CTC wastransmitted, no significant signal was received correctlythereafter.Remedy: Ask the operator of the other party to increase the transmissionlevel so that the signal may be received correctly.##757 [TX] In ECM transmission, DCN was received aftertransmission of PPS-MPS
