Chapter 1414-29T-14-58T-14-59T-14-60##670 [TX] In V.8 late start, the V.8 ability was detected in DISfrom the other party and, in response, CI wastransmitted; however, the procedure failed to advance,causing a T1 time-over conditionCause: CI was transmitted, but the other party failed to receive it correctlyand disconnect the line.Remedy: (1) Increase the transmission level so that the other party mayreceive CI correctly.(2) Prohibit the V.8/V.34 procedure.Cause: ANSam or DIS from the other party cannot be received correctly.Remedy: (1) Ask the operator of the other party to increase the transmissionlevel so that the signal may be received correctly.(2) Prohibit the V.8/V.34 procedure.##671 [RX] In V.8 call arrives, the procedure fails to advance tophase 2 after CM detection, causing a T1 time-overconditionCause: In phase 1, the other party cannot receive the signal correctly anddisconnect the line.Remedy: (1) Increase the transmission level so that the other party mayreceive the signal correctly.(2) Prohibit the V.8/V.34 procedure.Cause: In phase 1, the signal from the other party cannot be receivedcorrectly.Remedy: (1) Ask the operator of the other party to increase the transmissionlevel so that the signal may be received correctly.(2) Prohibit the V.8/V.34 procedure.##672 [TX] In V.34 transmission, the procedure fails to move fromphase 2 to phase 3 and later, causing a T1 time-overconditionCause: In phase 2, the other party cannot receive the signal correctly, anddisconnect the line.
