4- 42 Adjusting Amount of Media FeedTOPChapter 3Printing Methods forDifferent ObjectivesChapter 4Maintaining thePrinterChapter 5Using the Printer in aNetwork Environ-mentChapter 6TroubleshootingChapter 7Operation of theFunction MenusIndexContentsChapter 2Using a Variety ofMediaChapter 1Basic ProceduresAdjusting Amount of Media FeedPerform the procedure below to perform Adjust Band toadjust the amount of line feed if you see white lines or darkcolor lines in your printed images. As the band adjustmentpattern prints, the printer reads the results of the print andautomatically adjusts the settings of the amount of line feed forthe media currently loaded in the printer. Before you performthe band adjustment, make sure a roll or cut sheet A3 (L) sizeor wider is loaded in the printer.Importantz Before you adjust line feed, you must use theoperation panel to select media type for the paperloaded for printing. If the value of the media typeselection does not match the paper loaded for printing,you will not achieve good print results and the qualityof the printing will be poor.z Select Feed Priority > Band Joint in order to performAdjust Band.Notez If you are using cut sheets, make sure at least onesheet of unused A3 paper (not the blank sides of usedpaper) or larger are set.z There is no automatic adjustment for highlytransparent film. Execute Fine Tuning to perform theadjustment with manual entry. (→ P.4-43)Media Feed Adjustment Procedure1 If the printer power is off, press the Powerbutton to switch the printer on.Within a short time, Online or Offline is displayed.2 Press the Online button to display MAINMENU.3 Press [] or [] to select Adjust Printer,then press [].MAIN MENUAdjust Printer ↓DataInformation PowerOfflineMenuMessageOnlineCleaning(3 sec.)Stop/Eject(1 sec.)MAIN MENUHead CleaningOnlineCleaning(3 sec.)Stop/Eject(1 sec.)
