2- 33 Printing with RollsTOPChapter 3Printing Methods forDifferent ObjectivesChapter 4Maintaining thePrinterChapter 5Using the Printer in aNetwork Environ-mentChapter 6TroubleshootingChapter 7Operation of theFunction MenusIndexContentsChapter 2Using a Variety ofMediaChapter 1Basic ProceduresRemoving a RollFollow the procedure below to remove a loaded roll or whenthe media cannot be cut automatically. Or, if you areprinting on a media with the Eject Cut item of MediaConfiguration Tool (→ P.3-58) (→ P.3-127) set to Required,perform the same procedure when you see Cut by StopKey after printing finishes.Importantz When the roll media remaining detection function ison, you must follow a strict procedure to remove a roll.If you open the release lever and remove the rollbefore the media remaining bar code prints, the printerwill lose its ability to monitor the amount of mediaremaining on the roll.z After removing a roll from the printer, store it in itsoriginal vinyl bag. When you print on roll media thathas not been properly stored, the surface of the mediamay chafe or the print quality may be poor.1 Hold down the Stop/Eject button for at least1 second.2 Press the OK button. For the media when the Standard Cutteroperation is set to Enable:1. If the paper remains function is switched on forthe roll media, a barcode is printed on theleading edge of the roll.2. The roll is ejected at the back of the printer.Importantz Even if the roll paper remains function is on, if youopen the release lever without pressing the Stop/Ejectbutton the barcode does not print. In such a case, theroll remains function cannot be done with that roll.Remove RllMedia?Press OK/StopOnlineBkOnlineCleaning(3 sec.)Stop/Eject(1 sec.)P l a i n P a p e r X X
