2- 26 Printing with RollsTOPChapter 3Printing Methods forDifferent ObjectivesChapter 4Maintaining thePrinterChapter 5Using the Printer in aNetwork Environ-mentChapter 6TroubleshootingChapter 7Operation of theFunction MenusIndexContentsChapter 2Using a Variety ofMediaChapter 1Basic ProceduresPrinting with RollsLoading Roll MediaThis is the general procedure for loading roll media. After printing, remove the completed printout and anymedia loaded on the platen. (→ P.2-33, P.2-39) On the operation panel, select the roll media source.(→ P.2-26) Load the roll media in the roll holder slot. (→ P.2-27) Load the roll media on the platen. (→ P.2-30) On the printer operation panel, select the media type.(→ P.2-30) Adjust the amount of media feed. (→ P.4-42) Start the print job from the computer. (→ P.1-40)Importantz Make sure that the printer is switched on before youload roll media. If the loaded media does not match themedia type, this can affect the quality of printing. Selecting the Paper SourceWhen printing on roll media, select roll media as thepaper source on the operation panel.1 Press and hold the Paper Source button for1 second or more to light the Roll Medialamp.Pressing the Paper Source button alternates theselection between Roll Media and Cut Sheet.When a cut sheet is loaded, the printer will displayRemove CutSheet?.When another roll media is loaded, hold down theStop button for more than 1 sec., to display RemoveRllMedia?.2 If either a cut sheet or roll media is loaded inthe printer, press the OK button.Remove either the cut sheet or the roll media.(→ P.2-33, P.2-39)Remove RllMedia?Press OK/StopDataInformation PowerOfflineMenuMessageOffline Feed PapreOnlineCleaning(3 sec.)Stop/Eject(1 sec.)
