![Canon imagePROGRAF iPF6400 User Manual Manual pdf 627 page image](https://manuals-archive2.s3.amazonaws.com/4941979/ce874e3dc54db4c4d2a47037b798d458627f.jpg)
Note• You should normally select Update the printer control panel and printer driver.The custom paper is added to the control panel of the printer and to the printer driver of the PC you are using.• When the custom paper is correctly added to the printer driver, the name of the added custom paper is displayed inthe Edit Media Types dialog box that is opened by Add Genuine Paper in the Media Configuration Tool window.• After importing custom paper, adjust the paper feed amount for that custom paper. For details on the method foradjusting the paper feed amount, see "Automatic Banding Adjustment." →P.738WarningsWarningsTake note of the following warnings when added custom paper other than Canon genuine paper and feed confirmedpaper to the printer driver and the printer itself.About the Cutter• Depending on the paper, there are types that cannot be cut by the cutter unit, and types that speed deterioration ofthe blade and cause damage to the cutter. For thick paper, hard paper, etc. do not use the cutter unit, and insteadcut the roll paper using scissors, etc. after printing. In this case, select User Cut as the Automatic Cutting Set-tings in the Roll Paper Settings dialog box.Note• If the cutter is damaged, contact your Canon dealer for assistance.• For details on the methods for cutting roll paper, see "Specifying the Cutting Method for Rolls." →P.544About the Printhead• If the printhead rubs against the paper during printing, this may cause damage to the printhead. If the printhead isrubbing against the paper, configure the Vacuum Strength in the Step 5: Configure the amount of ink useddialog box as follows.• For paper-based media such as Heavyweight Coated Paper: Set to Strong or Strongest• For film-based media such as CAD Tracing Paper: Set to Standard, Strong, or Strongest• For thin paper of thickness 0.1mm or less: Set to WeakestNote• If the printhead still rubs even after changing the Vacuum Strength, set the Head Height to be higher in the Step 5: Config-ure the amount of ink used dialog box.• For details on how to handle the printhead rubbing against the paper, see "Paper rubs against the printhead." →P.892About Borderless Printing• When performing borderless printing on paper where the ink does not dry well, the cutter unit may leave scratcheswhere it touches the printed surface, or may not cut correctly. In this kind of situation, configure the amount of timeto wait for the ink to dry after printing using Drying Time in the Roll Paper Settings dialog box.Alternatively, if the paper cannot be cut well by the cutter, set the Automatic Cutting Settings to User Cut in theRoll Paper Settings dialog box, and cut the roll paper using scissors, etc.About the Print Quality• If the edges of images are blurry, set the Vacuum Strength to be weaker in the Step 5: Configure the amount ofink used dialog box.• If lines are warped or scratched, set the Head Height to be lower in the Step 5: Configure the amount of inkused dialog box.• If the amount of ink used is too much, wrinkles may appear and the ink may bleed in the printed material. Further-more, if the amount of ink used is too little, color production may be poor and lines may become scratched. In thiskind of situation, change the amount of ink used in the Step 5: Configure the amount of ink used dialog box.iPF6400 Warnings (Mac OS X)User's GuideHandling and Use of Paper Media Configuration Tool (Mac OS X)627