Setting Item Description, InstructionsPaper Details (The type of paperis displayed here.)(*1)Trim Edge First Selects whether or not to automatically cut the leading edge of the rollpaper when roll paper is loaded.(See "Cutting the Leading Edge of Roll Paper Automatically.") →P.548CutDustReduct. If you choose On, a line will be printed at the cut position when papercutting is selected. This option reduces the amount of debris given offafter cutting. It also helps prevent adhesive from sticking to the cutterand keeps the cutter sharp if you use adhesive paper. (See "ReducingDust from Cutting Rolls.") →P.550VacuumStrngth Specify the level of suction that holds paper against the Platen. (See"Adjusting the Vacuum Strength.") →P.744Scan Wait Time Specify the time to wait for the ink to dry between each scan (after theprinthead finishes moving in one direction), in consideration of howquickly the ink dries. Also specify the applicable area for the ink dryingtime. Select Entire area to apply the ink drying time after each scan un-til the document is fully printed. Select Leading edge to apply the inkdrying time after each scan only in the area 110–140 mm from the lead-ing edge. (The applicable length varies depending on the Print Qualitysetting.) Note that printing will take longer if you specify the Scan WaitTime setting. In particular, when Leading edge is selected, colors maybe uneven in the boundary between the areas with and without a dryingtime.Roll DryingTime Specify the time to wait for the ink to dry for each sheet.NearEnd RollMrgn Specify the minimum margin at the leading edge of roll paper to ensurebetter printing quality at the leading edge.Note that if you choose 3mm, it may lower the printing quality at theleading edge and affect feeding accuracy. The printed surface may bescratched, and ink may adhere to the leading edge. It may also causethe Platen to become soiled.NearEnd Sht Mrgn Specify a margin at the leading edge of sheets to ensure better printingquality at the leading edge.Note that if you choose 3mm, it may lower the printing quality at theleading edge and affect feeding accuracy. The printed surface may bescratched, and ink may adhere to the leading edge.BordlessOversize Select the amount of oversize extension of the original during border-less printing.Normally, we recommend that you set this to Standard.If it is set to Little, although it will reduce soiling on the back surface,white patches may remain on the printed surface.Manual Feed Select the Paper Feed Slot to use when printing on sheets. Normally,select Top. When printing on heavyweight paper such as POP Board,select Front.Return Defaults Choose OK to restore Paper Details to the default values.Paper Details Print the paper settings as specified in Paper Details.Keep Paper Type Select On when printing on a particular type of paper regularly. (See"Changing the Type of Paper.") →P.536*1: For information on the types of paper the printer supports, refer to the Paper Reference Guide. (See Paper Reference Guide.) Types ofpaper in the printer driver and related software (as well as on the Control Panel) are updated when you install the printer driver from theUser Software CD-ROM or if you update paper information with the Media Configuration Tool. (See "Updating paper information.")→P.529iPF6400 Menu SettingsUser's GuideControl Panel Printer Menu649
