3 Press ▲ or ▼ to select Adj. Fine Feed, and then press the OK button.4 Press ▲ or ▼ to select a setting value in the range -5 to 5, and then press the OK button.At this time, if banding in dark colors appears, select a setting value in the range 1 to 5, and if banding in lightcolors appears, select a setting value in the range -1 to -5.Adjusting Line LengthAdjusting Line LengthTo ensure that lines in CAD drawings are printed at exactly the right length, use Adjust Length to adjust the amountthat paper is advanced.There are two options in Adjust Length : AdjustmentPrint and Change Settings.• AdjustmentPrintAfter a test pattern is printed, you will measure the discrepancy based on the results of printing.• Change SettingsNo test pattern is printed. Instead, you will measure a document already printed to determine the discrepancy.Additionally, two modes are available in both AdjustmentPrint and Change Settings : A:High or B:Standard/Draft.Choose the mode that suits your particular printing application.• A:HighThis setting is applied when Highest quality or High is selected in Print Quality in the printer driver.• B:Standard/DraftThis setting is applied when Standard or Fast is selected in Print Quality in the printer driver.Note• We recommend executing the adjustment if you have changed the paper type or paper size.• Always check the Adj. Priority values before using Adjust Length. (See "Selecting a Feed Amount Adjustment Method.")→P.737Paper to PrepareWhen Using Rolls • An unused roll at least 254.0 mm (10.00 in) wide• High-precision rulerWhen Using Sheets • One sheet of unused paper of at least A4/Letter size• High-precision rulerPerform adjustment as follows.1 Load the paper.• Loading Rolls on the Roll Holder →P.531• Loading Rolls in the Printer →P.534• Loading Sheets in the Feed Slot →P.554Important• Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be completed correctlyunless the loaded paper matches the settings.2 On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-lect the Settings/Adj. tab ( ).Adjusting Line Length iPF6400User's GuideAdjustments for Better Print Quality Adjusting the feed amount742