Canon imagePROGRAF iPF9400S Basic Manual

Also see for imagePROGRAF iPF9400S: Function guide Troubleshooting guide Manual User guide Brochure & specs

Contents

"Replace roll with 10 in. wide or larger roll."Cause Corrective ActionThe loaded paper is too small.(When you have attempted to print a test print sheet or otherprinter status information.)Replace the roll with a roll 10 inches in width or larger as follows.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") →P.15(See "Removing the Roll Holder from Rolls.") →User's Guide2. Replace the roll with a roll 10 inches wide or larger.(See "Attaching the Roll Holder to Rolls.") →P.9(See "Loading Rolls in the Printer.") →P.11The printer will resume printing.Press ▲ or ▼ to select Stop Printing, and then press the OK button.PaprWidth MismatchPaprWidth MismatchCause Corrective ActionWhen Detect Mismatch in the Control Panel menu isset to Pause or Hold Job, the width of the loaded rolldoes not match the width specified in Fit Roll PaperWidth in the printer driver.Press ▲ or ▼ to select Print, and then press the OK button to resume printing.However, note that this error may cause paper jams and affect the printingquality.Press ▲ or ▼ to select Stop Printing, and then press the OK button.Follow these steps to replace the roll to match the width specified in the printerdriver.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") →P.15(See "Removing Rolls From the Roll Holder.") →User's Guide2. Replace with paper of the width configured in the printer driver.(See "Attaching the Roll Holder to Rolls.") →P.9(See "Loading Rolls in the Printer.") →P.11The printer now starts printing the print job.Make sure the roll width selected in the dialog box displayed when you selectFit Roll Paper Width in the printer driver matches the width of the roll loaded inthe printer, and then try printing again.Paper size not detected.Paper size not detected.Cause Corrective ActionPaper has been loaded askew, or warped paper has been loaded. Lift up the Release Lever and reload the pa-per.(See "Loading Rolls in the Printer.") →P.11(See "Loading Sheets in the Printer.")→P.18If "Not finished printing. Finish printingremaining jobs?" is displayed on the Dis-play Screen, press the OK button.Printing will resume, starting from the pageon which the error occurred.If this error recurs after you reload the roll,remove the Roll Holder from the printer,push the roll firmly in until it touches the RollHolder flange, and reload the Roll Holder inthe printer.(See "Attaching the Roll Holder to Rolls.")→P.9iPF9400S PaprWidth MismatchBasic GuideError Message Messages regarding paper131